Rakeshaxe

Search This Blog

10.12.1996

Get link
Facebook
X
Pinterest
Email
Other Apps

How to solve this 4 by 4 music square?

Ans :- ?

5s vs 6s six sigma

Get link
Facebook
X
Pinterest
Email
Other Apps

Comments

Power circuit for a 3-phase full-converter feeding RLE load

This post aims to provide a comprehensive overview of the power circuit utilized in three-phase full-converter systems feeding RLE (Resistive-Inductive-Electronic) loads. It will delve into the components, operation, benefits, and applications of this advanced power electronics technology. If all the diodes in the 3-phase full-converter bridge of Figure are substituted with thyristors, the resulting configuration, depicted in Fig(i), forms a three-phase full-converter bridge. This setup allows for the connection of a three-phase input at terminals A, B, C, with the RLE load linked across the output terminals. Similar to a single-phase full-converter, the thyristor power circuit in Fig. operates as a three-phase AC to DC converter when the firing angle delay falls within the range of 0°< α ≤ 90°. Beyond this range, between 90° < α < 180°, it functions as a three-phase line-commutated inverter. The preference for a three-phase full converter arises particularly in scenarios whe...

Discussion of 3φ full converters and semiconverters

Three-phase thyristor converter circuits are used in power electronics for various applications such as motor control, power transmission, and voltage regulation. These circuits typically consist of three thyristors connected in each phase of the converter. By controlling the firing angle of the thyristors, the output voltage and frequency can be adjusted to meet the requirements of the load. Large power loads often utilize three-phase AC to DC converters. Various types of three-phase phase-controlled converters include the three-phase half-wave converter, three-phase semiconverter, three-phase full converter, and three-phase dual converter. The three-phase half-wave converter is seldom used in industry due to its introduction of DC components in the supply current. Semiconverters and full converters are prevalent in industrial settings, while dual converters are reserved for reversible DC drives with high power ratings. The advantages of three-phase converters over single-phase conver...

Effect of Source Impedance on the Performance of Single-Phase and Three-Phase Full Converters

For single-phase and three-phase full converters, the derivation of output voltages, represented by the equations \( \frac{2V_{ml}}{\pi} \cos \alpha \) and \( \frac{3V_{ml}}{\pi} \cos \alpha \), assumes that the current transitions from the outgoing SCRs to the incoming SCRs occur instantaneously. This means that when the incoming SCRs T1 and T2 are fired in a single-phase full converter, the outgoing SCRs T3 and T4 are turned off as a result of the applied reverse voltage, causing the current to shift to SCRs T1 and T2 instantaneously. This condition holds true only if the voltage source has no internal impedance. In reality, the source does have internal impedance. If the source impedance is resistive, there will be a voltage drop across this resistance, reducing the average output voltage of the converter by \( I_0 \cdot r_s \) for a single-phase converter and by \( 2 I_0 \cdot r_s \) for a three-phase converter. Here, \( I_0 \) represents the constant DC load current, and \( r_s \...